9pm — 9" woofer plus midrange
Use for: cafés, jam sessions, practice, jazz with unamplified horns, recording studios, intimate stages.
16.25" H x 11" W x 11.875" D Approx. 29lbs weight
200 watts @ 8ohms. Switched for mid-cut at high volume.
Standard look: black taurus tolex, red/black fade (cab on the right)
Sensitivity: 90db F3: 49Hz F6: 39Hz
Two Speakon Combo Jacks, in parallel
• Side-ported, long and cuved vents (patent pending). These cabs offer superb F3 and F6, without port "chuffing", or driver-damaging over-extensions. And your bandmates will feel you, because the side-ported vents expand low end to both sides, not just in front of the cab.
• At any playing volume you can actually hear (and feel) fundamentals. When you get a full spectrum of bass sound, with solid lows at all volumes, you won't need to play as loud. The net result is overall lower SPL while still getting satisfying depth and bottom end in the mix.
• High extension, specialized woofers. They deliver low frequencies with surprising authority, which is the heart of the matter. All of your fundamentals, to the 22nd fret, are reproduced by the woofer. But the sonic complexity extends past the fundamental and initial harmonics. This is where the midrange comes in.
• Harmonic complexity and "touch" lies in the mids and upper mids. This is why our cabs use a woofer plus midrange, to create a rich and balanced, amazingly naturalistic sound. High power pro-audio midranges pick up where these woofers leave off, for articulate sound. Woofers can't deliver that harmonic subtlety, so we don't ask them to. The midrange does it. The custom crossovers make this into a singular, cohesive, and musical sound.
• There are no tweeters in Trudeep Bass cabs. Tweeters would not survive at frequencies from 1~2kHz. This is exactly the range where our midranges smoothly round out the low fundamentals from the woofers. The response of Trudeep Bass cabs ends at about 6.5kHz, for a bright sound without excessive string noise or brittle high end.
• High end passive electronics in custom, asymmetrical crossovers deliver rich harmonic tonalities for consistent, smooth reproduction across the frequency range. Heavy guage inductors and high power audio capacitors are used. The drivers are matched in sensitivity, needing NO heat-generating resisters in the crossovers.
• Components are hand-wired, point-to-point, with iso-elastic mounts, sealed from buffeting transients. The crossover housing, like the vents, forms part of the stiffening of the total cab, needing no additional braces.
